Distributor cap

May be supplied in black

 This part is due back in stock soon, call 01484 841395 to reserve yours

 12715432 GU12715432 12 71 54 32
 1271 5432 1271.5432 12.71.54.32

Old type 4 pin starter relay in metal case. Note that this has two large terminals and two smaller ones, depending on model you may need to fit wider spade connectors to fit this relay. See ELA10003 for large female spade connectors

 This part is due back in stock soon, call 01484 841395 to reserve yours

 12732500 GU12732500 12 73 25 00
 1273 2500 1273.2500 12.73.25.00

Oil pressure switch M12 thread, male spade connector

Superceded by ELA19670 . See ENA12640 for replacement crush washer if required

 Sorry, this part is no longer available.

 12768700 GU12768700 12 76 87 00
 1276 8700 1276.8700 12.76.87.00

Rectifier / diode board for Bosch charging systems. High quaility replacement part sourced from Germany

See our Bosch fault finder page for help diagnosing problems on your Bosch charging system.

 This part is due back in stock soon, call 01484 841395 to reserve yours

17704300-z 17704300 GU17704300 17 70 43 00
 1770 4300 1770.4300 17.70.43.00

3 pin plastic connector for headlight bulb spade connections

No longer available from Guzzi

 Sorry, this part is no longer available.

 17740364 GU17740364 17 74 03 64
 1774 0364 1774.0364 17.74.03.64

Alternator stator for Bosch charging systems, this does not include the plate and brush holders

To fit this you will need to solder in the three wires from the windings. Replacement rotors and brushes also available. See ELA00503 for a complete higher output upgrade for your charging system

 This part is available by special order, request a quote

 17712400 GU17712400 17 71 24 00
 1771 2400 1771.2400 17.71.24.00

Kit containing two replacement 60cm silicon HT leads, lead ends and 90° plug caps. The leads are suppied as a single double length lead so you can cut it into two leads of the exact required length. Includes crimp on lead ends for standard big twin 12v round coils

Suitable for most models with coils under the tank where the HT lead is not moulded into the ignition coil. We recommend checking what type of plug cap you have and measuring your existing cable run to check this part will fit

 This part is due back in stock soon, call 01484 841395 to reserve yours

Marelli phase sensor for Digiplex ignition and tacho

2 pin block connector

 This part is available by special order, request a quote

 20721610 GU20721610 20 72 16 10
 2072 1610 2072.1610 20.72.16.10

Motoplat ignition unit for one cylinder (2 required per bike)

Also known as Guzzi ref. 23721493, 27721435, 23721491, 23721490, 27721435

 This part is available by special order, request a quote

 23721494 GU23721494 23 72 14 94
 2372 1494 2372.1494 23.72.14.94

Protective cap for battery lead

 This part is due back in stock soon, call 01484 841395 to reserve yours

25707100-z 25707100 GU25707100 25 70 71 00
 2570 7100 2570.7100 25.70.71.00